Home
Shop
Wishlist0

L298 Motor Driver Module

85.00 EGP

Purchase this product now and earn 9 Points!
Buy Now
Availability: In Stock
SKU:300000009171
Description

The module with the popular L298N driver allows you to control the direction and speed of two DC motors. Thanks to the screw connectors, ARK power and engines can be easily connected by fastening the wires using a screwdriver. The control signals were output into popular gold pin connectors that allow you to combine the system with commissioning plates, for example, with Arduino using wires.

Leads
PIN DESCRIPTION
+12V The voltage of the motor’s power supply.
+5V The power of the theological part with the regulator – is active after you remove the jumper 5V.
 GND The weight of the system
OUT1, OUT2
The channel outputs of engine A.
OUT3, OUT4 The channel outputs of engine B.
ENA PWM signal to control the rotational speed of the engine A. By default, it is connected to 5 V by jumper -which means that the engine works with the maximum speed.
IN1, IN2 Control of channel A direction
ENB PWM signal to control the rotation speed of motor B. By default, connected to the 5 V by jumper – it means that the engine works with maximum speed.
IN3, IN4 Direction control of channel B
The truth table of driver L298
IN1 / IN3 IN2 / IN4 THE OUTPUTS OF THE ENGINES
high state low state The motor rotates with the maximum given speed using PWM (different from 0) in a clockwise direction.
low state high state The motor rotates at the maximum given speed using PWM (not equal to 0) in a counterclockwise direction.
low state low state When indicated high state at the PWM input – fast braking of the motors (fast stop).
high state high state When indicated high state at the PWM input – fast braking of the motors (fast stop).
high state high state When indicated low state at the PWM input – free braking (soft stop).
Specifications
  • Supply voltage: 12 V
  • Supply voltage of the logic part: 5 V
  • Built-in voltage regulator 5 V to power the logic part with the possibility of disconnection via jumper
  • Maximum output current: 2 A per channel
  • Module to control two DC motors or one stepper motor
  • The outputs for the motors and the power inputs were displayed on the screw connectors ARK
  • The input pins of the logic part are available on the gold pin connectors – 2.54 mm pitch
  • The board consists of all necessary for the proper operation of the controller, passive components
  • The system has a mounted radiator
  • Tile sizes: 43.5 x 43.5 x 26 mm

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Back to Top
Product has been added to your cart