Home
Shop
Wishlist0

Nokia 5110 LCD Display Module

125.00 EGP

Purchase this product now and earn 13 Points!
Buy Now
Availability: In Stock
SKU:300000009396

The name of this product itself is enough to explain its origin. Yes of course !!! this LCD module was used in old Nokia 5110/3310 cell phones. Now its been widely used by hobbyists for graphics, text etc.

Though it’s an industrial module, this LCD display is extremely easy to use. The Nokia 5110 is a basic graphic LCD screen for lots of applications. It was originally intended for as a cell phone screen.

This Nokia 5110 LCD Display Module is mounted on an easy to solder PCB. The Nokia 5110 LCD Module uses a Philips PCD8544 LCD driver, which is designed for mobile phones.

Nokia 5110 LCD Display Module is a low-cost monochrome LCD module comprised of 84 X 48 pixels that can be used to display rich graphics and text content. This module is a revision that accepts 3-5V input. So no extra level shifter is needed.

It uses the PCD8544 controller, which is the same used in the Nokia 3310 LCD. The PCD8544 is a low power CMOS LCD controller/driver, designed to drive a graphic display of 48 rows and 84 columns. All necessary functions for the display are provided in a single chip, including on-chip generation of LCD supply and bias voltages, resulting in a minimum of external components and low power consumption. The PCD8544 interfaces to microcontrollers through a serial bus interface.

Pin Configuration:-

  • RST– reset
  • CE– chip selection
  • DC– data/commands choice
  • DIN– serial data line
  • CLK– serial Clock Speed.
  • VCC– 3.3V
  • LIGHT– backlight control terminal
  • GND– power negative

Features of Nokia 5110 LCD Display Module:-

  • 84 X 48 dot matrix LCD, can show 4 lines of characters.
  • Use serial interface communicate with the master processor, the number of interface signal line reduced greatly, only 8 signal lines including power and GND.
  • Support different types of MCU, such as the Arduino, AVR, SPI, MCS51 and so on.
  • Transfer rate up to 4Mbps, can full speed write display data without waiting time.
  • Can use the conductive glue to connect the module to the printed board, without cables. The metal hooks on the module can fix the module on the printed board, which is very easy to install and replace.
  • LCD controller/driver chip has been bound to LCD chip, the volume of LCD is small.
  • Low power supply, the working current in a normal situation is lower than 200µA and has the power-down mode.
  • \”LIGHT\” linked with GND, the backlight to be lit.
  • Need you to compress the screen and PCB tighter, might be got loose after the delivery.
  • Use a 3.3V controller, otherwise, the display could be quite vague.

Nokia5110 Datasheet 

Back to Top
Product has been added to your cart