TMC2208 V1.2 Stepping Motor Mute Driver Stepstick Silent

TMC2208 Stepper Motor Driver Module

MC2208 is an ultra-quiet two-phase stepper motor drive chip, continuous drive current 1.4A, peak current 2A, voltage range 4.75V-36V, 256 subdivision. The flexible microPlyer interpolation unit provides up to 256 subdivisions, allowing perfect sinusoidal control even in systems with limited pulse frequencies; these are also designed because stealthChop2 ultra-quiet technology is widely used in 3D printing.
This product is known as 3D Printer TMC2208 Stepstick Stepper Motor Driver Module + Heat Sink, TMC2208 Stepper Motor Driver Module with Heat Sink for 3D Printer Part

Features:

• Configuration: Step/DIR or UART
• Micro-steps: 1/256
• Current Loading: 1.2A continuous, 2A peak
• Supply Voltage: 4.75 ~ 36V
• Single Wire UART: for advanced configuration options

Features/Specs:

• Model: TMC2208
• Interface: Step/Dir
• Configuration: CFG Pins or UART
• Native Micro steps: Up to 1/256
• MicroPlyer Micro steps: 1/256
• Logic Voltage VIO: 3 ~ 5V
• Motor Voltage VM: 5.5  ~ 36V
• Motor Phase Current: 1.2A RMS, 2.0A Peak
• Internal V-Regulator: Enabled
• Size (LxWxH): 20 x 15 x 11 mm

Note !!!:

• Make sure not to connect the motor when measuring voltage, otherwise driver will burn out.
• When used on Ramps1.4 or MKS Gen, please remove the 3 jumpers under socket.
• Pay attention to direction, don’t insert wrongly, or it will burnt out.
• The motor direction is opposite to that of A4988 and DRV8825, please adjust the firmware or adjust the motor wiring if you want to replace A4988.

Package Includes:

• 1 x TMC2208 Stepper Motor Driver Module
• 1 × Heat Sink
• 1 × Screwdriver