Home
Shop
Wishlist0

MAX7219 8X8 Dot LED Matrix Display Module FC-16 (Solder)

105.00 EGP

Buy Now
Availability: In Stock
SKU:N/A

The MAX7219 is compact, serial input/output common-cathode display drivers that interface microprocessors to 7-segment numeric LED displays of up to 8 digits or 64 individual LEDs. It includes an on-chip BCD code-B decoder, multiplex scan circuitry, segment and digits drivers, and an 8×8 static RAM that stores each digit. Only one external resistor is required to set the segment current for all LEDs.

Features

  • MAX7219 Driver Board
  • A single module can drive an 8*8 common cathode matrix
  • Module with input and output interface, supporting multiple module cascade
  • 4 fixing screw holes, 3mm aperture , can be fixed with M3 copper column

Specifications

  • Input Voltage: 3.7 to 5.3 V
  • Input Current: 320 mA
  • Color: Blue , Red , Green
  • Dimensions:3.2cm X 3.2cm X1.5cm

Application

  • Bar-Graph Displays
  • 7-Segment Displays
  • Industrial Controllers
  • Electronic Panel Meters
  • LED Matrix Displays
  • Display of symbols, simple graphics and texts.

Input Connector

The header pins on the “IN” side is the main input connector. “Vcc” connects to 5V.  Due to the fairly high current draw of the display (up to 250mA if the brightness is cranked all the way up), it is recommended to keep the brightness turned down to < 50% to avoid overheating the MCU voltage regulator if there are other peripherals also attached to this supply.    “GND” connects to ground which needs to be common with the MCU.

The other pins are for the SPI interface.  “DIN” is the Data In.  “CS” is Chip Select (sometimes labeled as LOAD) and “CLK is the Clock pin.  These lasts 3 pins are connected to any digital outputs on the microcontroller.  Which pins they connect to is defined when an instance of the LedControl is created as shown in the program below.

1 x 5 Header

  • VCC –   Connect to 5V.
  • GND –  Connect to system ground.  This ground needs to be in common with the MCU.
  • DIN –   Connect to any digital pin on MCU.
  • CS / LOAD – Connect to any digital pin on <CU.
  • CLK –    Connect to any digital pin on MCU.

Output Connector

The break-out pins on the other end of the assembly are used if it is desirable to daisy-chain multiple displays.  In this case, the “DOUT” is Data Out and it connects to the next modules “DIN” Data in pin.  The other pins are passed straight-thru

1 x 5 Header

  • VCC –   Connect to 5V on next module if looping power through.
  • GND –  Connect to GND on next module
  • DOUT –   Connect to DIN on next module.
  • CS / LOAD –  Connect to CS / LOAD on next module
  • CLK –    Connect to CLK on next module

MAX7219 Datasheet 

PACKAGE INCLUDES:

  • 1.3″ 8 x 8 dot matrix of red LEDs
  • MAX7219 LED Driver board
  • 8-pin female socket (x2)
  • 5-pin right-angle male header
  • 5-pin straight male header
Color

Red, Green, Blue

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Back to Top
Product has been added to your cart