Relay Module 12V (8 Channel) Low Level Trigger

• Maximum load: AC 250V/10A, DC 30V/10A.
• The chip optocoupler isolation, strong driving ability, stable performance, trigger current 5mA.
• Working voltage is 12V.
• Each channel of the module can be set up by a low-level trigger.
• Fault-tolerant design, even if the control line is broken, the relay will not act.
• Power indicator (green), 8 relay status indicator (red).
• The interface design is humanized, all interfaces can be directly connected through the terminals, so it is very convenient.
• Module size: 142mm x 50mm x 18.5mm (length x width x height).
• With 4 fixing bolt holes, hole 3.1mm, pitch 131mm x 49.5mm

Relay output: there is a 24 wire interface, all interfaces can be directly connected to lead to facilitate user use.

1. NO1–NO8: Relay normal open, the relay suspends before pulling in, and then short-connect with the COM.
2. COM1–COM8: Relay common interface
3. NC1–NC8: Relay normal close, short connected with COM before pulling in and suspended after pulling in.