-
-
-
-
-
GenPro DT10 RGB Creative Lighting with Projection Filters – 10W Portable LED Photography Light
1,500.00 ج.م1,500.00 ج.م× -
-
-
-
AT89S51 8-Bit Microcontroller PDIP-40
Low-power 8-bit AT89S51 microcontroller in PDIP-40 package; 4 KB ISP Flash, 128 bytes RAM, 32 I/O lines, enhanced features for embedded control.
95.00 ج.م
متوفرالكود 1328005711660
اشترِ الآن
شحن لجميع محافظات مصريصلك حتى باب بيتك
الدفع عند الاستلامادفع عند وصول طلبك
غير متأكد أنه يناسب مشروعك؟اسألنا على واتساب - نرد بسرعة
AT89S51 8-Bit Microcontroller PDIP-40
Low-power, high-performance CMOS 8-bit AT89S51 microcontroller with 4KB of ISP flash memory. The device uses Microchip high-density, nonvolatile memory technology and is compatible with the industry-standard 80C51 instruction set and pinout. On-chip flash allows program memory to be reprogrammed in-system or by a conventional nonvolatile memory programmer.
Features
- Compatible with MCS®-51 Products
- 4K Bytes of In-System Programmable (ISP) Flash Memory
- Endurance: 1000 Write/Erase Cycles
- 4.0V to 5.5V Operating Range
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 128 x 8-bit Internal RAM
- 32 Programmable I/O Lines
- Two 16-bit Timer/Counters
- Six Interrupt Sources
- Full Duplex UART Serial Channel
- Low-power Idle and Power-down Modes
- Interrupt Recovery from Power-down Mode
- Watchdog Timer
- Dual Data Pointer
- Power-off Flag
- Fast Programming Time
- Flexible ISP Programming (Byte and Page Mode)
PINOUT
| Pin | Pin Name | Description |
|---|---|---|
| 1 | P1.0 | Port 1 bit 0 (general-purpose I/O) |
| 2 | P1.1 | Port 1 bit 1 (general-purpose I/O) |
| 3 | P1.2 | Port 1 bit 2 (general-purpose I/O) |
| 4 | P1.3 | Port 1 bit 3 (general-purpose I/O) |
| 5 | P1.4 | Port 1 bit 4 (general-purpose I/O) |
| 6 | P1.5 | Port 1 bit 5 (general-purpose I/O) |
| 7 | P1.6 | Port 1 bit 6 (general-purpose I/O) |
| 8 | P1.7 | Port 1 bit 7 (general-purpose I/O) |
| 9 | RST | Reset input (active high) |
| 10 | P3.0 / RXD | Port 3 bit 0 or UART receive |
| 11 | P3.1 / TXD | Port 3 bit 1 or UART transmit |
| 12 | P3.2 / INT0 | Port 3 bit 2 or external interrupt 0 |
| 13 | P3.3 / INT1 | Port 3 bit 3 or external interrupt 1 |
| 14 | P3.4 / T0 | Port 3 bit 4 or external Timer 0 input |
| 15 | P3.5 / T1 | Port 3 bit 5 or external Timer 1 input |
| 16 | P3.6 / WR | Port 3 bit 6 or external data memory write strobe |
| 17 | P3.7 / RD | Port 3 bit 7 or external data memory read strobe |
| 18 | XTAL2 | Crystal oscillator output |
| 19 | XTAL1 | Crystal oscillator input |
| 20 | GND | Ground (0 V) |
| 21 | P2.0 / A8 | Port 2 bit 0 or Address bit 8 for external memory |
| 22 | P2.1 / A9 | Port 2 bit 1 or Address bit 9 for external memory |
| 23 | P2.2 / A10 | Port 2 bit 2 or Address bit 10 for external memory |
| 24 | P2.3 / A11 | Port 2 bit 3 or Address bit 11 for external memory |
| 25 | P2.4 / A12 | Port 2 bit 4 or Address bit 12 for external memory |
| 26 | P2.5 / A13 | Port 2 bit 5 or Address bit 13 for external memory |
| 27 | P2.6 / A14 | Port 2 bit 6 or Address bit 14 for external memory |
| 28 | P2.7 / A15 | Port 2 bit 7 or Address bit 15 for external memory |
| 29 | PSEN | Program Store Enable — for external program memory read |
| 30 | ALE / PROG | Address Latch Enable or Program pulse input |
| 31 | EA / VPP | External Access Enable / Programming voltage input |
| 32 | P0.7 / AD7 | Port 0 bit 7 or Address/Data bit 7 when external memory accessed |
| 33 | P0.6 / AD6 | Port 0 bit 6 or Address/Data bit 6 when external memory accessed |
| 34 | P0.5 / AD5 | Port 0 bit 5 or Address/Data bit 5 when external memory accessed |
| 35 | P0.4 / AD4 | Port 0 bit 4 or Address/Data bit 4 when external memory accessed |
| 36 | P0.3 / AD3 | Port 0 bit 3 or Address/Data bit 3 when external memory accessed |
| 37 | P0.2 / AD2 | Port 0 bit 2 or Address/Data bit 2 when external memory accessed |
| 38 | P0.1 / AD1 | Port 0 bit 1 or Address/Data bit 1 when external memory accessed |
| 39 | P0.0 / AD0 | Port 0 bit 0 or Address/Data bit 0 when external memory accessed |
| 40 | VCC | Positive supply voltage (typically +5 V) |
Specifications
| Attribute | Value |
| RAM Size | 128Byte |
| Program FLASH Size | 4K@x8bit |
| Operating Temperature Range | -40℃~+85℃ |
| Supply Voltage Range | 4V~5.5V |
| CPU Core | 51Series |
| Peripherals / Functions / Protocol Stacks | WDT |
| Internal Oscillator | Internal oscillator included |
| Maximum Frequency | 24MHz |
| GPIO Ports Number | 32 |
منتجات ذات صلة
