Li-Pol TP4056 charger TP4056 single 1S 3.7V micro USB cell with protections
Simple charger for 1-purpose lithium-polymer batteries with a nominal voltage of 3.7V. The maximum charging current is 1000 mA. The system is powered via the microUSB connector or via wires connected to the IN+ and IN- inputs. The module is protected against excessive discharge below 2.5 V and excessive current consumption above 3 A.
Outputs
The module has 6 solder fields and a micro USB connector.
Pin Configuration:
No: | Pin Name | Description |
1 | OUT + | This pins outputs the positive voltage from battery. It should be connected to the circuit which has to be powered by the battery |
2 | B + | Outputs positive voltage from USB cable to charge to battery. It should be connected to the positive of the battery |
3 | B – | Outputs negative voltage from USB cable for charging battery. It should be connected to negative of the battery |
4 | OUT – | This pin outputs negative voltage from battery. It should be connected to the ground of circuit which has to be powered by the battery |
5 | IN + | Should provide +5V, can be used if charge cable not available |
6 | IN – | Should provide ground of the +5V supply, can be used if charge cable not available |
7 | LED Red | This LED turns on while the battery is charging |
8 | LED Green | This LED turns on after the battery is fully charged |
Specifications
- Layout: TP4056
- Power supply voltage: (micro USB or IN connectors) from 4.5 V to 5.5 V
- Charging voltage: 4,2 V
- Maximum charging current: 1 A
- Socket: micro USB(micro USB cable can be purchased separately)
- Two signal lights
- Red: charging
- Green: full charge
- Short circuit protection
- Overcharge protection
- Over-discharge protection
- Overcurrent protection
- Protection against discharge below 2.5 V
- Protection against current consumption over 3 A
- Module dimensions 28 x 18 mm
Attention!
Before connecting the battery, check the polarity of the plug. |
Useful links |