USB ASP AVR Programmer

USB ASP AVR Programmer

These AVR programmers are based on USBASP firmware and connect to your computer’s USB port.

USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega8 and a few passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed. Some of the key features include: a. Works under multiple platforms. Linux, Mac OS X and Windows are tested, b. Programming speed is up to 5kBytes/sec, and c. Slow SCK option to support targets with low clock speed (< 1.5MHz).

Features

• Allows you to read or write the microcontroller EEPROM, firmware, fuse bits and lock bits
• Support for Windows, Mac OS X and Linux
• 5 KB/sec maximum write speed
• Software controlled SCK option to support targets with low clock speed (< 1.5MHz)
• 10 pin ISP interface (conforms to standard ISP 10-pin pinout)

Working Software

• AVRdude – Version 5.2 or later. AVRdude is available for many platforms.
• Khazama AVR Programmer – An AVRdude GUI for MS Windows
• BASCOM-AVR – Version 1.11.9.6 or later
• eXtreme Burner – An easy to use GUI application for MS Windows.

Specifications:

• Size: 70 x 20 mm
• Supported Software: AVRDude 5.2 or higher

Watch a video walkthrough of this process

It can be especially useful for cases where:

• you want to access a device using a libusb-based application
• you want to upgrade a generic USB driver
• you want to access a device using WinUSB

Download  Zadig from here

Kit Includes:

• 1x USBasp programmer
• 1x 10 pin ISP cable